The water pump plays an essential role in the heavy equipment cooling system. The cooling system and the diesel engine cannot function properly without a good quality water pump because of the overheating problem. Many customers complain to us that the equipment often breaks down due to overheating, especially in hot weather. They usually purchased from us because they want to reduce the repair costs. But how to correctly repair the water pump?
Here are some steps
-Old Components Removing Process
-
Remove the blots and cover from the housing
-
Take out the bolts and washer
-
Remove the ball bearing and gear
-
Mount the pump on a hydraulic press after removing the snap ring
-
Remove the impeller from the internal ball bearing and shaft
-
Take out all seals from the housing and clean it
-New Components Installing Process
-
installing the sealing lid
-
installing the ball bearing and shaft as a unit by using the hydraulic press
-
Use hydraulic press to install seal ass’y and impeller into the housing
-
Replace the snap ring and lock the unit
-
Replace the bolt
-
Installing new gasket kits and hardware
If you are still not sure about the repair steps, you can also simply replace the water pump as a whole at relatively lower costs with FridayParts.
Simply search for the water pump part number on our website www.fridayparts.com
Alternatively, tell our customer representatives the part numbers or simply send a photo of your old water pump. They will confirm the part information for you within 24hours. Our customer services team is here for you 24/7, feel free to reach out anytime everywhere.
